grease_fitting_relocation_hose
ready_to_install_grease_fitting_extension_hosegrease-relocation-hose-bulkhead-fittinggrease-fitting-relocation-hoselength-of-grease-hose

Custom Length – Grease Fitting Relocation Hose

$23.20$60.48

Custom length – made to your measurements and ready to install.  Relocate grease fittings anywhere.

Note:  The bearing end of our extension hoses has a 1/8″ MNPT thread.  Thread adapters may be required for bearings with other thread types.

Enter length in feet and inches below. Shortest possible length is 6 in. longest is 12 ft.

Clear selection
SKU: Custom Length Extension Hose Category:

Product Description

Ready-to-install grease fitting relocation hose – custom fabricated to your measurements. High pressure hose ends are permanently installed on thermoplastic high pressure hose. The 1/8″ inside diameter saves grease because one ounce of grease will fill 12′ of hose. High pressure rated hose will withstand the extreme pressures generated by grease guns. Hoses tolerate equipment vibration and will flex with moving machinery.

Hose Ends
All grease fitting relocation hose come with a 1/8″ male NPT thread on the grease port end and a 1/8″ female NPT thread on the bulkhead fitting. A 1/8″ NPT grease fitting is installed on the bulkhead fitting.  Hose length will be measured from the tip of the grease port fitting to the face of the bulkhead on the other end. Delivered length may vary by up to half an inch from the specified length.

Included Hardware

  • 1/8″ inside diameter grease extension hose made to your measurements.
  • Bulkhead fitting
  • standard Zerk style grease fitting (any style grease fitting with a 1/8″ NPT thread can be field installed)

 

Our grease fitting relocation hoses include everything needed to relocate your grease fittings in many applications. Additional fittings and adapters may be needed depending on your specific equipment.

Specifications:
Hose Strength: 2,500 psi continuous, 10,000 psi. bursting pressure
Minimum Bending Radius: 1.8″
Dimensions: 1/8″ ID x .32″ OD x your specified length
Bulkhead Mounting Hole: 7/16″ diameter up to 1/2″ thickness
Temperature Range:  -40ºF to 200ºF
Finish: hose ends and fittings have a corrosion resistant trivalent chromium finish.

Note: Please measure carefully.  Custom length hoses are made to your specifications, hoses are not returnable unless defective.

Optional Fittings and Accessories

  • Thread adapters will be needed if your bearing grease port is any thread other than 1/8″ NPT.
  • 90º and 45º ells are also available for connecting hose to the grease port at these angles.
  • Bulkhead rail: the bulkhead fitting can be installed into one of our bulkhead mounting rails or can be installed into any 7/16″ hole in material up to 1/2″ thickness.

 

Other fittings and accessories can be found on our catalog page.

Shortest possible custom hose length is 6 inches, longest is 12 feet.